Traspir Evo 300
Can be used as a Temporary Weather Protection Cladding to allow an early start on the internal linings. High UV stability, up to 9 months full exposure. Plus permanent exposure for partially open claddings with open joints up to 50mm wide and with up to 40% of the surface uncovered. Ideal for low pitched roofs.
Monolithic acrylic mix film, applied to polyester (PL) reinforcing layer.
High UV Stability
9 month resistance to UV rays with full exposure to radiation and no protection. High thermal resistance up to 120C.
Flame Retardent
B-S1, d0 Flame resistant Euroclass certification based on EN 13501-1
High Mass, Non-Flamable, Thermal Stability
The ideal membrane for residential or commercial use in areas of climate extremes, partially open cladding, high UV exposure, and/or areas where operating temperatures exceed the standards.
Where can it be applied?
Codes and Dimensions
| code | excode | description | tape | HxL[m] | A[m2] |
|---|---|---|---|---|---|
| TTTEVO300 | D42524 | TRASPIR EVO 300 TT | TT | 1.5 X 50 | 75 |
Technical Specifications
| property | standard | value |
|---|---|---|
| Mass per unit area | EN 1849-2 | 300 g/m2 |
| Thickness | EN 1849-2 | 0.5 mm |
| Straightness | EN 1848-2 | conforming |
| Water vapour transmission (Sd) | EN 1931/EN ISO 12572 | 0.04 m |
| Maximum tensile fore MD/CD | EN 12311-1 | 320/200 N/50 mm |
| Elongation MD/MC | EN 12311-1 | 30/35% |
| Resistance to tearing MD/MC | EN 12310-1 | 130 /140 N |
| Water-tightness | EN 1928 | class W1 |
| Water column | EN 20811 | > 500 cm |
| UV stability with joints up to 50 mm wide with up to 40% of the surface uncovered | EN 13859-1 | permanent |
| UV resistance without final cladding | EN 13859-1 | 9 months |
| Temperature resistance | - | -40/+120˚c |
| Reaction to fire | EN 13501-1 | Class B-s1, d0 |
| Resistance to penetration of air | EN 12114 | <0.02 m3/m2h50pa |
| After ageing: | - | - |
| • maximum tensile force MD/CD | EN 13859-1 | 310 / 190 N/50 mm |
| • water-tightness | EN 13859-1 | class w1 |
| • elongation MD/CD | EN 13859-1 | 28 / 33 % |
| Flexibility at low temperature | EN 1109 | -40C |
| Dimensional stability | EN 1107-2 | < 1 % |
| Thermal conductivity (λ) | - | 0.3 W/mK |
| Specific heat | - | 1800 J/kgK |
| Density | - | approx. 600 kg/m3 |
| Water vapour resistance factor (μ) | - | approx. 80 |
| Recommended installation pitch | - | >10 degrees |
| Driving rain test | TU Berlin | passed |
| VOC emissions | - | 0 % (class A+) |
| Joint strength | EN 12317-2 | >280 N/50 mm |